Seat LEON 2024 - Connecting and Disconnecting

Parking and manoeuvring
239
Reverse Assist (Rear View Camera)
–
When the vehicle approaches objects
that are not on the ground surface or that
protrude from it. These objects may be out-
side the camera angle when reversing.
Note
●
It is important to take great care and pay
special attention if the driver is not familiar
with the system.
●
The reverse assist reference lines disap-
pear when the rear lid is open.
Connecting and disconnecting
Connect the reverse assist
●
With the ignition switched on, select reverse
gear.
●
OR: in the infotainment system select >
Driver assist > Park assist.
Disconnect the reverse assist
●
Drive forward at a speed of at least 15 km/h
(9 mph).
Shown on the display
The system’s functions and representations
may vary depending on the equipment.
The assistant's image view changes when the
factory-fitted tow hitch is electronically con-
nected to a trailer ›››page306.
Reverse assist functions and symbols
When the reverse assist is connected, you can
make adjustments using the function buttons.
Some adjustments are equipment-dependent.
Exit the current display
Switch to angle parking ›››page240
Switch to the trailer hitching assistance
function
Switch to cross trac
Adjust the display: brightness, contrast
and colour.
Switch to park assist ›››page228
Display/hide the park assist view
Guide lines
Green horizontal lines: extension of the vehicle.
Yellow lines: vehicle path depending on the
steering angle.
Assistance function for hitching a trailer
On vehicles with a factory-fitted towing device,
this function can be used to move the vehicle
close to a tow bar.
Auxiliary lines are shown in the infotainment
system.
Green lines: distance to the trailer hitch. The
distance between the lines is approx. 0.30 m
Yellow line: pre-calculated direction of the
trailer hitch depending on how the steering
wheel is turned.
Cross trac
This view helps to monitor trac behind the
vehicle and can be used, for example, when
exiting garages or narrow exits.