Seat LEON 2024 - Page 230

228
Parking and manoeuvring
A
B
C
D
symbol and a greyed-out graphic segment. If
necessary, the parking system switches o the
aected zone.
If the park assist is not working properly, a con-
tinuous audible signal sounds for a few seconds
when it is switched on. If applicable, a message
to this eect is displayed on the instrument
cluster display
●
Check if one of the causes indicated above
has occurred.
●
Once the source of the problem has been
eliminated, the system may be reconnected.
●
If the problem persists, consult a specialised
workshop.
Park Distance Control Plus
(Park Pilot)
Description
Fig.153 Parking aid view on the Infotainment
system display.
Parking aid plus assists the driver by giving
visual and audio warnings about obstacles de-
tected in front of and behind the vehicle.
The bumpers are fitted with sensors. When
an obstacle is detected, it is indicated by au-
dible signals and in the Infotainment system
›››Fig.153.
When moving close to an obstacle, it is possible
to know if the obstacle is in front of the vehicle
or behind it according to the sound frequency.
The approximate measurement range of the
sensors is:
1.20 m
0.90 m
1.60 m
0.90 m
As you approach the obstacle, the frequency of
the audible signals will increase. The signal will
sound continuously at around 0.30 m: Stop the
vehicle!
If the separation is maintained, the warning vol-
ume is reduced after about 2.5 seconds.
Error messages
If a an error or fault message is displayed on
the instrument cluster in Park Assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated next
time the parking aid is connected.
If a rear sensor is faulty, only the obstacles in
the front area are detected. If a front sensor is
faulty, only the obstacles in the rear area are
displayed. The symbol is displayed.
We recommend taking the vehicle to a special-
ised workshop to have the fault repaired.
Trailer mode
On vehicles with a factory-mounted trailer
hook, when the trailer is connected, the rear
sensors will not activate when reverse gear is
engaged or button
is pressed in the Infotain-
ment system ( > Assistants). Therefore, any