1)
Do the opposite in right-hand drive vehicles.
●
Release the reverse gear.
●
The adjusted position for the rear view mirror
is stored.
Activating the passenger side exterior mirror
settings for reversing
●
Turn the exterior mirror control knob to posi-
tion
1)
.
●
Engage reverse gear with the ignition
switched on. The right-hand exterior rear-view
mirror will move to the saved position.
The passenger side exterior mirror leaves the
saved reversing position when the vehicle is
travelling faster than approx. 15km/h (9mph),
or if the control is turned from position to an-
other position.
WARNING
Folding the exterior mirrors in and out care-
lessly can cause injury.
●
Only fold or unfold the exterior mirror if
there is no one in the path of the mirror.
●
When moving the mirror, be careful not to
pinch your fingers between the mirror and
the mirror holder.
NOTICE
●
Before washing the vehicle in an automatic
car wash, please make sure that the exterior
mirrors are folded in to prevent them from
being damaged.
●
The electrically folding exterior mirrors
must only be operated electrically, not by
hand, as this could damage their electric
drive.
For the sake of the environment
Do not leave the exterior mirror heating on
for longer than necessary. Otherwise it cau-
ses unnecessary energy consumption.
Note
If the electrical adjustment should fail to op-
erate, both of the mirrors can be adjusted
by hand by lightly pressing the edge of the
mirror glass.
Sun protection
Sun blind
Fig.113 Sun visor
Options for adjusting driver and front pas-
senger sun visors
●
Lower the sun visor towards the windscreen.
●
The sun visor can be pulled out of its mount-
ing and turned towards the door ›››Fig.113
1
.
●
Swing the sun visor towards the door, longitu-
dinally backwards.
There is a vanity mirror on the sun visor, with
a cover. When the cover is opened
2
a light
comes on.
The lamp goes out when the vanity mirror cover
is closed or the sun visor is pushed back up.
To Next Page
Loading...
