Variable luggage compartment floor
Fig.185 Variable luggage compartment floor:
raised position; lowered position.
Fig.186 Variable boot floor: tilted position.
Variable floor in high position
●
To move from the low position to the high po-
sition, lift the floor using the handle ›››Fig.185
1
, and pull it back until the front of the floor
has fully passed the supports
2
.
●
Move the floor forward over the supports as
far as the rear seat backrest and then lower the
floor with the handle
1
.
Variable floor in low position
●
To move from the high position to the low po-
sition, lift the floor using the handle ›››Fig.185
1
, and pull it back until the front of the floor
has fully passed the supports
2
.
●
Now let the front part fall to the floor and
slide the floor forwards as far as the rear seat
backrest; lower the floor at the same time with
the handle
1
.
Variable floor in the tilted position
When the variable floor is tilted you can access
the spare wheel or anti-puncture kit area.
●
Lift the variable floor in the high position using
handle ›››Fig.185
1
, pull it up and push it
towards the backrest of the rear seats until it
folds along the hinge line and the movable part
of the floor is resting on itself.
●
Rest the floor on its housings ›››Fig.186 (ar-
rows).
WARNING
●
Always secure objects, even when the lug-
gage compartment floor is properly lifted.
●
Only objects that do not protrude more
than 2/3 the height of the floor may be car-
ried between the rear seat and the raised
luggage compartment floor.
●
Only objects that do not weigh than ap-
proximately 7.5 kg may be carried between
the rear seat and the raised luggage com-
partment floor.
To Next Page
Loading...
