Seat LEON 2024 - Page 134

132
Lights
System limitations
In the following cases, the main beam headlight
must be switched o manually because the
main beam assist will not disconnect it on time
or disconnect it at all:
●
On insuciently lit roads with highly reflective
signs.
●
If road users are insuciently lit up, e.g. pe-
destrians or cyclists.
●
On closed curves, when the trac in the
opposite direction is partially hidden, on pro-
nounced slopes or inclinations.
●
On roads with trac in the opposite direction
and with a central reservation barrier where the
driver can see over it e.g. lorry drivers.
●
In case of fog, snow or heavy rainfall.
●
In case of swirling dust or sand.
●
If the windscreen is damaged in the camera's
field of vision.
●
If the camera's field of vision is misted up, dirty
or covered by a sticker, snow or ice.
●
If the camera is damaged or if the power sup-
ply has been cut o.
WARNING
The comfort features of the main beam assist
must not lead you to take any risks. The sys-
tem is not a replacement for driver concen-
tration.
●
You must always control the main beam
yourself and adapt it to the light, visibility
and trac conditions.
●
The main beam regulator may not recog-
nise all driving situations correctly and may
operate with limitations in certain circum-
stances.
●
When the camera’s field of view is dirty,
covered or damaged, the operation of the
main beam regulator may be aected. This
also applies when the vehicle’s lighting in-
stallation is modified, e.g. when additional
headlamps are installed.
NOTICE
To avoid aecting the operation of the sys-
tem, take the following points into considera-
tion:
●
Clean the field of vision of the camera reg-
ularly and make sure it is free of snow and
ice.
●
Do not cover the field of vision of the cam-
era.
●
Check that the windscreen is not damaged
in the area of the camera’s field of view.
Note
●
The headlight flasher can be turned on and
o manually at any time with the turn signal
and main beam lever ›››page130.
●
If there are objects that radiate light in the
camera's area of influence, e.g. a portable
navigation system, this may aect the oper-
ation of the main beam assist system.
“Coming home” and “Leaving home”
function (exterior orientation light-
ing)
The “Coming home” and “Leaving home” func-
tion lights up the vehicle’s immediate surround-
ings when getting into and out of it in the dark.
This light is automatically controlled by a light
sensor.
Turning on the “Leaving home” light
●
Unlocks the vehicle (if the automatic dipped
beam function is switched on and the light
sensor detects darkness).
Turning o the “Leaving home” light
●
It turns o automatically once the lights o
delay time has elapsed.
●
OR: lock the vehicle.