Selco EB 70 - Chapter 1. Main Parts and Foreseen Uses; General Description of the Machine


BIESSE S.p.A. Woodworking Machinery
(l127h024.fm-141101)
&KDSWHU 0DLQ3DUWVDQG)RUHVHHQ8VHV
In this chapter the main parts of the machine basic configuration are described and information is
given on the foreseen uses of the machine. Information concerning the optionals is found in the
following chapters.
 *HQHUDO'HVFULSWLRQRIWKH0DFKLQH
This machine is a NC panel sizing centre with a single cutting line. More information on possible
machining, loading methods and piece characteristics is described in the paragraph 1.4
“Foreseen Use” on pages 1 - 6.
On the following paragraph a general plan view of the machine is shown and its main parts are
identified and described.
As a general rule, the machine is fitted for piece loading on its left-hand side (left-hand side
machine). However, should there be particular requirements, the customer may request a machine
fitted for piece loading on the right-hand side (right-hand side machine). For any further
information, please see paragraph 2.6 “Right-hand Side Machine” on page 2 - 2.
,1)250$7,21
3OHDVHQRWHWKDWLQWKLVPDQXDODVDJHQHUDOUXOHWKHLOOXVWUDWHGPDFKLQHLVWKHOHIWKDQGVLGH
PDFKLQH