Selco EB 70 - PLC Keyboard


&KDSWHU
&RQWUROVDQG6LJQDOOLQJ'HYLFHV
BIESSE S.p.A. Woodworking Machinery
(l103h036.fm-141101)
 3/&.H\ERDUG
This keyboard may be used to enable different functions. Each key controls a machine action only,
however, after the cycle start button has been pressed.
(5(6(7.H\: when held down for at least 3 seconds, this key serves to place all
mobile machine organs on standby. It has no effect if pressed while machining is in
progress.
(.H\IRU3LHFHVZLWK3URMHFWLQJ)DFLQJV this is used when machining pieces with
projecting facings and using the special stops.
/LW = function enabled.
($XWRPDWLF%ODGH3URMHFWLRQ.H\: this is used to optimise the blade projection
according to the thickness of the pieces to be machined. This function may be enabled
at any time, although if it is enabled while a cut is in progress, it will not be activated
until the next cut.
/LW = function enabled.
(.H\IRU6FRULQJZLWKWKHPP%ODGH: this is used for machining with the
scoring blade with a diameter of 200 mm.
/LW = function enabled.
(.H\IRU6FRULQJ3RVWIRUPHG3LHFHV: this is used to cut postformed pieces using
the scoring blade with a diameter of 300 mm. When this function is enabled this also
automatically enables the function described here below.
/LW = function enabled.
(.H\IRU6FRULQJZLWKWKHPP%ODGH: this is used for machining with the
scoring blade with a diameter of 300 mm.
/LW = function enabled.
(.H\IRU3LHFH6LGH3XVKLQJ this is used for pushing pieces sideways using the
relevant device. This function may be enabled at any time, although if it is enabled
while a cut is in progress, it will not be activated until the next cut.
/LW = function enabled.
(,PPHGLDWH&RPSOHWH&XW.H\ this is used to make an immediate cut of the same
length as that set in the relevant parameter of the numerical control software (see the
Software User’s Manual).
/LW = function enabled.
(9HQWLODWLQJ)DQ6WDUW.H\: this is used to start the ventilating fans on the air jet
panel supports.
/LW = function enabled.
(,PPHGLDWH/RQJ&XW.H\ this is used to make an immediate cut of the same
length as that set in the relevant parameter of the numerical control software (see the
Software User’s Manual).
/LW = function enabled.
7*8*9

