Selco EB 70 - Using a Cutting Pattern; Using a Series of Cutting Patterns


BIESSE S.p.A. Woodworking Machinery
(l133h014.fm-141101)
&KDSWHU
0DFKLQLQJ
5. Load the piece.
6. Press the cycle start button (white) again (ref. B6, page 3 - 3).
8VLQJD&XWWLQJ3DWWHUQ
This machining mode is used from the PATTERNS page of the numerical control (to open this
page press F4 from the main menu), and it is usually used to carry out a cutting pattern on a
specified quantity of pieces.
To carry out this type of machining proceed as follows:
1. Make sure that the start button (green) on the main button pad (ref. B1, page 3 - 3), is lit.
2. Press F1 from the PATTERNS page to enable the required program.
3. Press the blade start button (white) on the main button pad (ref. B3, page 3 - 3).
4. Press the blade start button (white) on the main button pad (ref. B6, page 3 - 3).
5. Load the piece.
6. Press the cycle start button (white) again (ref. B6, page 3 - 3).
8VLQJD6HULHVRI&XWWLQJ3DWWHUQV
This machining mode is used from the WORKLIST page (to open this page press F5 from the main
menu), and it is usually used to carry out two or more cutting patterns in succession on a specified
number of pieces.
To carry out this type of machining proceed as follows:
1. Make sure that the start button (green) on the main button pad (ref. B1, page 3 - 3), is lit.
2. Press F1 from the WORKLIST page to enable the list of programs.
3. Press the blade start button (white) on the main button pad (ref. B3, page 3 - 3).
4. Press the cycle start button (white) on the same button pad (ref. B6, page 3 - 3).
5. Load the piece.
6. Press the cycle start button (white) again (ref. B6, page 3 - 3).