Selco EB 70 - Foreseen Use


&KDSWHU
0DLQ3DUWVDQG)RUHVHHQ8VHV
BIESSE S.p.A. Woodworking Machinery
(l127h024.fm-141101)
 )RUHVHHQ8VH
The machine is a numerical control panel sizing centre with one cutting line for pieces with the
characteristics and dimensions as indicated in the paragraph “Piece Characteristics and
Dimensions”. This machine may be operated by one person only. The operator may be assisted by
another person for the stages of piece loading and unloading.
3LHFH&KDUDFWHULVWLFVDQG'LPHQVLRQV
It is possible to machine solid wood, fibre boards, chip boards, plywoods, and MDF (medium
density fibre boards) with the following dimensions:
/HQJWKDQG:LGWK
The machine is equipped, according to the
requirements of the customer, to machine one of
the maximum dimensions given here below:
n 3200 x 3100 mm
n 4400 x 4250 mm
0DFKLQDEOH+HLJKWRIWKH3LOHRI3LHFHV
In order to obtain a “rough cut” of an acceptable
quality, the maximum height of the pile of pieces
being machined must be such as that the teeth
may come out of the pieces. It is therefore
recommended to use the following value:
n EB 70 = 80 mm
Nevertheless, should a “finished cut” be required, it is not possible to define exactly the maximum
height of the pile of pieces being machined, since this measurement depends upon the surface
type of the pieces, on their calibration, on the quality and composition of the material, the type of
tool used, and on tool wear and tear.