Selco EB 70 - Axes Movement Speed Variation; Identification of Main Operating Areas


BIESSE S.p.A. Woodworking Machinery
(l104h044.fm-141101)
&KDSWHU
%DVLF&RQFHSWV
 $[HV0RYHPHQW6SHHG9DULDWLRQ
Axis movement speed variation, which may only be used for the CARRIAGE axis, is usually
carried out when testing a program. This is done to establish the most suitable speed for the
material to be machined, or to be able to observe axis movements better during particularly critical
points of the program. Speed is varied by manually turning the override control. The percentage
speed variation is displayed in a special field by the numerical control software.
 ,GHQWLILFDWLRQRI0DLQ2SHUDWLQJ$UHDV
This section identifies the areas in which the main machining stages are carried out and is aimed
at simplifying the location of the machine parts or devices that are mentioned in this manual..
$ /RDGLQJDQG8QORDGLQJ$UHD : the area in which the material for machining is loaded and
unloaded.
% 0RYHPHQW$UHD: the area in which the pieces are positioned for cutting.
& &XWWLQJ$UHD: the area in which the cutting operations are executed.
$ %&