Selco EB 70 - Safety Devices


BIESSE S.p.A. Woodworking Machinery
(l127h024.fm-141101)
&KDSWHU
0DLQ3DUWVDQG)RUHVHHQ8VHV
 6DIHW\'HYLFHV
As well as various casings, covers, and other equipment fitted for the safety of the operator, which
are situated in different points, the machine is provided with safety devices as follows:
$ (PHUJHQF\%XWWRQ; this is located in the main control panel as well as in other locations
close to the control panel and it is used to shut down the machine immediately. For further
information, please see Chapter 3. “Controls and Signalling Devices”.
% &XWRXW9DOYH; this is used to perform maintenance or repairs on the machine in safety
conditions and it may be locked in order to avoid any possible tampering from unauthorized
personnel. This valve is operated by turning anticlockwise the orange-coloured knob, thus
allowing for the discharge of the pneumatic system and for the shutdown of the air flow from
the general supply system. To reset the machine and put it into operation, press and turn
clockwise the same knob.
& 6DIHW\&XUWDLQ: this prevents hands from entering the cutting areas during machining.
' 6DIHW\%DU: this protects the operator from the risk of being crushed by the presser and is
equipped with interlock microswitches.
( 2SHUDWLQJ6HFWLRQ$FFHVV'RRU: this is a mobile guard equipped with interlock
microswitches with lock to allow risk-free access to the operating section.
(
'
&
%
$