BIESSE S.p.A. Woodworking Machinery
(l140h005.fm-141101)
&KDSWHU
%DVLF8VHV
6ZLWFKLQJ2II
1. Wait until the end of the machine working.
2. Set the control software for switching off.
3. Carry out a regular stop of the machine as described in the paragraph 5.2 “Stop” on page 5 -
2.
4. Turn the main machine switch to 0 (ref. A, page 3 - 2), and lock it, if any, and then do the
same with that of the factory’s general system.
5. Close the pneumatic circuit in the point in which it is connected to the factory’s general
system.
6. Discharge and lock the pneumatic system by using the cut-out valve (ref. B, page 1 - 5) and
then lock the valve, if any.
To Next Page
Loading...