BIESSE S.p.A. Woodworking Machinery
(l133h014.fm-141101)
&KDSWHU 0DFKLQLQJ
This chapter describes the methods and procedures to follow when carrying out machining
operations.
0DFKLQLQJ0RGHV
The following paragraph contains all of the possible methods for carrying out machining
operations. Indications are given with regard to how to enable functions, specific uses, and the
respective possible loading methods for each machining mode. Procedures for machining mode
execution are also given. For further information about machining enabling, see the Software
User’s Manual.
0DNLQJDQ,PPHGLDWH&XW
This machining mode is used by pressing one of the specific keys on the PLC keyboard (ref. E,
page 3 - 2) and is usually used to make one or more cuts without having to program them into the
numerical control software.
To carry out this type of machining proceed as follows:
1. Make sure that the start button (green) on the button pad (ref. B1, page 3 - 3), is lit.
2. If a piece with specific dimensions is required, place the PUSHING DEVICE axis at the
desired position.
3. Load the piece.
4. Press one of the immediate cut keys on the PLC keyboard to choose and enable (ref. E8,
E10, E12, page 3 - 4) the type of cut required (short, long, complete).
5. Press the blade start button (white) on the main button pad (ref. B3, page 3 - 3).
6. Press the cycle start button (white) on the same button pad (ref. B6, page 3 - 3). Machining
will start and will stop when the presser rises again.
To Next Page
Loading...