Selco EB 70 - Page 29


BIESSE S.p.A. Woodworking Machinery
(l103h036.fm-141101)
&KDSWHU
&RQWUROVDQG6LJQDOOLQJ'HYLFHV
(5HDU&ROOHW6WRS.H\this is used to drive the collets on the rear stop. To avoid
the risk of crushing, the safety curtain will lower when collet clamping is enabled.
(,PPHGLDWH6KRUW&XW.H\ this is used to make an immediate cut of the same
length as that set in the relevant parameter of the numerical control software (see the
Software User’s Manual).
/LW = function enabled.
(-2*.H\: this is used to move an axis, selected using the numerical control
software, in a negative direction.
(-2*.H\; this is used to move an axis, selected using the numerical control
software, in a positive direction.
/4,
/4,