Selco EB 70 - Making Cuts for Square-shaped Openings

To Next Page

To Previous Page



&KDSWHU

0DFKLQLQJ

BIESSE S.p.A. Woodworking Machinery

(l133h014.fm-141101)

0DNLQJ&XWVIRU6TXDUHVKDSHG2SHQLQJVRSWLRQDO

This machining mode is used from the BORING EDITOR page (to open this page press ← or F11

and F4 from the main menu), and it is usually used to program and make openings in pieces that

will be used for kitchen work tops where sink units or cook tops will be fitted.

To carry out this type of machining proceed as follows:

1. Make sure that the start button (green) on the main button pad (ref. B1, page 3 - 3), is lit.

2. Press F1 from the BORING EDITOR page to enable the list of programs.

3. Press the blade start button (white) on the main button pad (ref. B3, page 3 - 3).

4. Press the cycle start button (white) on the same button pad (ref. B6, page 3 - 3).

5. Load the piece.

6. Press the cycle start button (white) again (ref. B6, page 3 - 3).