Selco EB 70 - Chapter 5. Basic Uses; Start-up


BIESSE S.p.A. Woodworking Machinery
(l140h005.fm-141101)
&KDSWHU %DVLF8VHV
In this chapter, the procedures relative to the main basic uses of the machine are described in
order to operate the machine correctly. In other words, the following operations are illustrated:
machine start-up, stop and restart.
 6WDUWXS
1. Turn the main switch to position 1 (ON) (ref. A, page 3 - 2).
2. Start the company main pressure
pneumatic system and open the cut-out
valve (ref. B, page 1 - 5) press and turn
clockwise the knob $.
3. Start the system for chips suction, to which
the machine is connected, and check that the sectioning guillotine in the connection pipe is
open.
4. Press the start button (green) on the main button pad (ref. B1, page 3 - 3).
Every time the machine is started-up, it is necessary to check the correct operation of the main
safety devices, and to proceed as follows:
n Press the emergency push-button (ref. F, page 3 - 2) and check that the start button (green),
located on the main button pad (ref. B1, page 3 - 3), is switched off. Carry out this operation
on all emergency push-buttons.
n Turn clockwise the orange-coloured knob $ of the cut-out valve (ref. B, page 1 - 5) and then
check that the FR unit pressure gauge (ref. L, page 1 - 3) indicates 0 bar.
n Lift slightly the safety bar (ref. D, page 1 - 5) and check that the start button (green) located
on the main button pad (ref. B1, page 3 - 3) is switched off.
Should one of these devices not operate correctly, please inform the maintenance personnel or the
BIESSE Client Service Department.
$