&KDSWHU
0DFKLQLQJ
BIESSE S.p.A. Woodworking Machinery
(l133h014.fm-141101)
2. Press the start button (green) on the main button pad (ref. B8, page 3 - 3).
3. Press F3 to restart the suspended program.
4. Turn the pushing device selector on the main button pad to the left (ref. B8, page 3 - 3).
5. Press the cycle start button (white) on the main button pad (ref. B6, page 3 - 3).
6. Press the blade start button (white) on the same button pad (ref. B3, page 3 - 3).
3LHFH/RDGLQJ
To load the machine it is necessary to position the piece/s against both the side stop and the rear
collet stops, which, after the desired machining program has been enabled, will have moved into
the proximity of the cutting area.
To Next Page
Loading...