'
BIESSE S.p.A. Woodworking Machinery
(a112h005.fm-141101)
$SSHQGL[' 'HFRPPLVVLRQLQJ'HPROLWLRQ
During the life cycle of the machine it may become necessary to dismantle it for transfer to another
site. If this is the case, proceed as indicated below.
1. Turn the machine off and disconnect it from all power sources.
2. Remove and put away all the tools that are in the machine.
3. Clean the machine and protect parts that are subject to corrosion using suitable products.
4. For transport and installation of the machine at the new site, use the methods and procedures
described in this manual.
The machine uses lubricating oil and grease. To neutralize the lubricant fluids which remain
attached to parts of the machine and cannot be re-used, use degradable solvents of an approved
type. For evacuation of recoverable lubricant fluids empty the tanks and deliver the fluids to the
local authority in charge of disposal. Any batteries, accumulators, buffer batteries for electronic
cards and conditioners that may be found in the machine must also be disposed of in a suitable
manner.
When the machine reaches the end of its technical working life it must be totally decommissioned
so that it can no longer be used for the purposes for which it was designed and built. This
procedure allows for re-use of the parts and raw materials contained in the machine. If any parts
are used again it must be for purposes other than those for which the machine was originally
constructed.
BIESSE declines all liability for damage to persons of things that may derive from any secondary
use of single parts of the machine for functions or assemblies other than those originally
contemplated. BIESSE recognizes no implicit or explicit suitability for specific purposes of any
parts of the machine which are used again after final decommissioning in view of demolition.
To Next Page
Loading...