$
$SSHQGL[$
6DIHW\LQIRUPDWLRQ
BIESSE S.p.A. Woodworking Machinery
(l109h012.fm-141101)
2. Check for perfect balance of rotating tools and make sure they are perfectly sharp and
suitable for the work to be performed.
3. Never use tools beyond their speed limit, which is impressed on the surface of the tool or
indicated in some way by the manufacturer.
4. Before installing any tool in its seating make sure that the guide and centring surfaces have
no dents and are perfectly clean.
5. In each tool apply only the prescribed torque to screws, bolts, nuts and rings.
6. Always make sure that the direction of rotation of the tool is the same as that of the spindle in
which it is mounted.
7. Never exceed the limits indicated in this manual or otherwise prescribed by BIESSE.
$ 3UHSDUDWLRQDQGPDFKLQLQJ
1. Wear protective clothing of the approved type (glasses, gloves, helmet and footwear) in
compliance with the standards and regulations in force on the essential health and safety
requirements in the workplace.
2. Never attempt to modify the programs managing safety devices. BIESSE declines all
responsibility for any damage to persons or goods resulting from unauthorised modifications
of this kind.
3. The machine must be set up by one person only. Ensure that nobody else approaches the
machine during setting up operations.
4. When entering the area inside the safety fence, remove the key from the limit switch on the
door, to prevent anybody from restarting the machine.
5. Never leave tools on the machine when setting up has been completed.
6. Before starting work, check that there is nobody within the danger area.
7. Make sure that nothing is likely to impede normal movement of the machine along the axes,
and that all casings, doors and protective covers are properly in place and safely fastened.
8. Before starting work, check to make sure that the tools installed in the machine have not been
tampered with in any way.
9. Never operate the machine while under the influence of any medicine, drugs or drink that may
reduce levels of vigilance and reflexes.
10. Always keep the working area clean and tidy.
11. Never place hands inside blade passage openings.
12. Never mount the machine.
To Next Page
Loading...