SeQual Technologies Eclipse 2 - Page 4

4
Table of Tables
TABLE 1: PULSE PROFILES...........................................................................................................................18
TABLE 2: FLOW MODES FOR DC POWER SUPPLY OPERATION. ............................................................38
TABLE 3: ECLIPSE STARTUP SEQUENCE INDICATIONS...........................................................................57
TABLE 4: SAMPLE ECLIPSE MAINTENANCE RECORD ..............................................................................60
Table of Illustrations
FIGURE 1: ECLIPSE SYSTEM BLOCK DIAGRAM.........................................................................................12
FIGURE 2: FLOW SENSOR BOARD DIAGRAM.............................................................................................15
FIGURE 3: CONTROL PANEL BUTTONS AND INDICATORS ......................................................................14
FIGURE 4: ECLIPSE SERVICE PORT............................................................................................................20
FIGURE 5: AC POWER SUPPLY ....................................................................................................................21
FIGURE 6: DC POWER SUPPLY ....................................................................................................................22
FIGURE 7: ECLIPSE POWER CARTRIDGE...................................................................................................23
FIGURE 8: POWER CARTRIDGE STATUS GAUGE......................................................................................25
FIGURE 9: DC POWER SUPPLY INPUT POWER SWITCH ..........................................................................37
FIGURE 10: CLEANING THE AIR INLET FILTER...........................................................................................40
FIGURE 11: MAINTENANCE TOOLS..............................................................................................................45
FIGURE 12: REMOVING SCREWS TO OPEN THE FRONT COVER............................................................46
FIGURE 13: OPENING THE FRONT COVER.................................................................................................46
FIGURE 14: REMOVING THE CONTROL PANEL RIBBON CABLE.............................................................. 47
FIGURE 15: DISCONNECTING THE OXYGEN OUTLET TUBE. ...................................................................48
FIGURE 16: FRONT COVER REMOVAL. .......................................................................................................48
FIGURE 17: CONTROL PANEL RIBBON CABLE INSTALLATION. ...............................................................49
FIGURE 18: REMOVING THE 9-VOLT BATTERY..........................................................................................50
FIGURE 19: DISCONNECTING THE 9-VOLT BATTERY. .............................................................................. 50
FIGURE 20: REMOVING THE HEPA FILTER.................................................................................................51
FIGURE 21: DISCONNECTING THE HEPA FILTER. .....................................................................................52
FIGURE 22: INSTALLING THE HEPA FILTER................................................................................................52
FIGURE 23: REMOVING THE COMPRESSOR INTAKE FILTER...................................................................54
FIGURE 24: INSTALLING THE COMPRESSOR INTAKE FILTER. ................................................................55
FIGURE 25: SEQUAL RECOMMENDED TEST SETUP TO VERIFY PERFORMANCE OF OXYGEN
CONCENTRATOR.......................................................................................................................
56
FIGURE 26: DATA OUTPUT FORM................................................................................................................58
FIGURE 27: ECLIPSE OXYGEN SYSTEM SIMPLIFIED BLOCK DIAGRAM. ................................................66
FIGURE 28: TOP CASE COMPONENTS........................................................................................................66
FIGURE 29: BOTTOM CASE COMPONENTS................................................................................................67
FIGURE 30: REMOVAL OF ATF MODULE PRODUCT HOSE .......................................................................68
FIGURE 31: REMOVAL OF ATF MODULE PRESSURE AND VACUUM TUBES..........................................68
FIGURE 32: REMOVE ATF MODULE FROM ECLIPSE CASE. .....................................................................69
FIGURE 33: ATF MODULE GROMMET INSTALLATION ...............................................................................69
FIGURE 34: TUBE ROUTING UNDER ATF MODULE....................................................................................70
FIGURE 35: PRODUCT TANK INLET AND OUTLET CONNECTIONS..........................................................72
FIGURE 36: PRODUCT TANK REMOVAL......................................................................................................73
FIGURE 37: OXYGEN TUBING ROUTING .....................................................................................................74
FIGURE 38: CONTROL MODULE REMOVAL (ATF MODULE NOT SHOWN FOR CLARITY).....................75
FIGURE 39: CONTROL MODULE INSTALLATION. .......................................................................................76
FIGURE 40: BONDING THE BUZZER TO THE CASE. ..................................................................................77
FIGURE 41: BUZZER INSTALLATION............................................................................................................77
FIGURE 42: CONTROL MODULE CONNECTOR DIAGRAM.........................................................................78