SeQual Technologies Eclipse 2 - Oxygen Circuit; Remove and Replace the ATF Module; Figure 30: Removal of Atf Module Product Hose; Figure 31: Removal of Atf Module Pressure and Vacuum Tubes

68
Oxygen Circuit
Remove and Replace the ATF Module
NOTE:
There are no serviceable parts inside the ATF Module. Do not attempt
to disassemble or modify the ATF Module.
7. Remove the Unit Cover as described in the section Remove and Replace the Unit Cover.
8. Cut the green tie as shown below, and disconnect the silicone tube that goes into the product port
of the ATF; this tube comes from the Product Tank.
Figure 30: Removal of ATF Module Product Hose.
9. Cut the green cable tie that secures the silicone tube to the braid tube at shown in below Figure.
.
Figure 31: Removal of ATF Module Pressure and Vacuum Tubes.