34
WARNING:
• Ensure adequate clearance around AC Power Supply.
• The AC Power Supply is universal input, but the AC power cord is
appropriate to specific country’s electrical service. Ensure that
power cord is appropriate to country’s electrical service.
CAUTION:
• DO NOT connect the Eclipse to an extension cord or electrical
outlet controlled by a switch.
NOTE:
When removing the AC Power Supply from the Eclipse, remove the
plug from the AC outlet before removing the AC Power Supply plug
from the Eclipse..
International safety standards require the use of hospital grade AC power cords when using the Eclipse in
a medical care facility. Contact SeQual to obtain a hospital grade AC power cord for the Eclipse if
necessary.
Connecting the DC Power Supply
The Eclipse DC Power Supply provides easy travel for your patient. There are two settings on the DC
Power Supply. Ensure the DC Power Supply is set-up properly to the vehicle being used. In order to
ensure correct operation and safety, you must help your patient install the DC Power Supply in their
vehicle by following the instructions in the Users Manual.
To install the DC Power Supply, follow these steps:
1. Consult your patient’s vehicle owner’s manual for DC Accessory outlet requirements.
CAUTION:
The DC Power Supply is designed for 12VDC vehicle electrical
systems. Do not attempt to operate with 6V, 24V, or other vehicle
electrical system.
2. Set switch on DC Power Supply to “10A” for a 15A or less outlet. Set the switch to “15A” for a
20A or greater outlet.
3. Always secure the Eclipse and DC Power Supply in the vehicle.
4. Attach the Power Supply plug to the Eclipse.
5. Start the vehicle’s engine before inserting the DC power supply plug into the DC Accessory
outlet.
6. Insert supply plug into DC Accessory outlet.
7. Use the Eclipse in Pulse Flow mode if prescribed by your clinician
To Next Page
Loading...