6.23
6.6 PRESSURE COMPENSATION KIT S1100997B
Item Description Part No
12
23
Pressure transducer assembly
O-Ring BS113 Viton A
01100991B
2323-6057
6.7 INTERCHANGEABILITY OF BOARDS AND SOFTWARE
The following Table lists the part numbers of older printed circuit boards and the equivalent new
part numbers. Fitting of the specified boards will not invalidate any safety approvals.
TABLE 6.1 EQUIVALENT PRINTED CIRCUIT BOARDS
Board Type Previous
Part Number
Current Part Number
Microprocessor
Current Output
Analogue to Digital Converter
Relay
Amplifier
Data Output
Power Supply Unit
01100915 (Note1)
01100918
01100918A
01100918B
01100918D (Note 3)
01100909
01100929
01100916
01100906
01100926
01100905
01100925
01100925A (Note 2)
01100907
01100958
S1100918C
S1100918C
S1100918C
S1100918C
S1100918D
S1100939
S1100929A
S1100916A
S1100936
S1100936
S1100925B
S1100925B
S1100925B
S1100927
S1100968
Note 1. The microprocessor board 01100915 may be replaced with 01100918, 01100918A
01100918B, 01100918C or 01100918D providing that the correct software is fitted, see
Table 6.2.
Note 2. When the 01100925B is replacing an 01100925A, remove link N-M and install link L-N.
This is also necessary if the uncalibrated oxygen reading is greater than the high
tolerance limit for the span calibration gas.
Note 3. The 01100918D is fitted as standard to ISSEP INIEX purged units, and MUST be
replaced with an S1100918D only.
To Next Page
Loading...
Need help?
General
