2.3
SECTION 2 INSTALLATION OF ANALYSER
This section includes installation instructions for the various options, information for connecting
the analyser units together and for the electrical and sample gas connections.
Installation Overview
1. Mounting of analyser - Section 2.3
2. Sample gas connections - Section 2.5
3. Electrical supply connections - Section 2.6
4. Transducer to Control unit interconnections (separated systems only) - Section 2.8.
5. Interface to Control unit interconnections (max separation systems only) - Section 2.9
6. Analogue output, alarm and auto-calibration connections - Section 2.11.
2.1 SAFETY CONSIDERATIONS
2.1.1 General Safety Requirements
Specific standards of safety are not included in this manual, since requirements of relevant
authorities vary widely.
WARNING
The installer must be satisfied that the analyser installation conforms
to the relevant safety requirements and that the installation is safe
for any extremes of conditions which may be experienced in the
operating environment of the analyser.
The safety precautions described in the following installation instructions ensure that the existing
safety features of the instrument are not impaired during installation. The precautions do not
guarantee a safe installation if other relevant safety codes are ignored.
2.1.2 Hazardous Area Requirements
If the analyser is being installed in a hazardous area then any "Special Conditions for Safe Use"
and/or "Schedules of Limitation" as detailed in the Safety Certification must be adhered to.
A summary of the certificates are in Appendix 1. Copies of the certificates and variations/revisions
are supplied with certified product as a supplement part number 01100 008A.
To Next Page
Loading...
Need help?
General
