Connecting to a server should only take a few seconds. If the LED is
showing this state for too long, then please see more information in the
Troubleshooting section.
openSPOT4 is connected to the Wi-Fi network and a special connector is
active (ex. Null connector or AutoCal):
openSPOT4 is connected to the selected server and is standing by:
openSPOT4 is connected to the Wi-Fi network, but there's a problem with
the internet connection:
The LED will show this state if the openSPOT4 is connected to a Wi-Fi
network, trying to connect to the selected server, but it can't because
there's a problem with the internet connection. This error can be caused if
the router, network, or the internet service provider is using a proxy or
some kind of traffic filtering which blocks the openSPOT4 from connecting.
Modem transmitting:
To Next Page
Loading...
