EasyManuals Logo

Sharp MX-M260 Operation Manual

Sharp MX-M260
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #136 background imageLoading...
Page #136 background image
134
REPLACING THE TONER CARTRIDGE
To check how much toner remains in the toner cartridge (p.137), hold down the [COPY] key. The amount of toner
remaining will appear in the display. When less than 25% of the toner remains, obtain a new toner cartridge as soon
as possible. When "READY TO COPY. (PREPARE A NEW TONER.)" appears in the display, the toner cartridge
must be prepared. When "TONER SUPPLY IS LOW." appears in the display, be sure to have a new cartridge on
hand for replacement at any time as little toner remains. When "CHANGE THE TONER CARTRIDGE." appears in
the touch panel, the toner cartridge must be replaced. Follow these steps to replace the cartridge.
1
Press gently on both sides of the front
cover and pull it open.
2
Pull the toner cartridge out while
pressing the lock release lever.
When pulling out the
toner cartridge, place
your other hand on the
cartridge.
3
Remove the new toner cartridge from
the bag. Grasp both ends of the
cartridge and shake it horizontally
about 4 or 5 times.
4
While holding down the lock release
lever, insert along guides inside the
machine until the cartridge locks into
place.
5
Close the front cover.
Do not throw the toner cartridge into a fire. Toner may fly and cause burns.
Store toner cartridges out of the reach of small children.
If a toner cartridge is stored on end, the toner may harden become unusable. Always store toner cartridges on
their side.
If a toner cartridge other than a SHARP-recommended toner cartridge is used, the machine may not attain full
quality and performance and there is a risk of damage to the machine. Be sure to use a
SHARP-recommended toner cartridge
When running long copy jobs or copying originals with many areas of solid black, "TONER REPLENISHMENT IN
PROGRESS." may appear in the touch panel and copying may stop even though the cartridge still has toner.
When this occurs, the toner is being replenished. Replenishment will last about three minutes. When toner
replenishment finishes, copying resumes.
Caution
Note
After removing the toner cartridge, do not
shake it or tap it. Doing so may cause
toner to leak from the cartridge.
Dispose of the old toner cartridge in
accordance with local regulations.
Toner cartridge
lock release lever
Note
If dirt or dust adheres to the toner cartridge,
remove it before installing the cartridge.
Note
Downloaded From ManualsPrinter.com Manuals

Table of Contents

Other manuals for Sharp MX-M260

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp MX-M260 and is the answer not in the manual?

Sharp MX-M260 Specifications

General IconGeneral
Print TechnologyLaser
Print Speed26 ppm
Max Print Resolution600 x 600 dpi
Copy Speed26 cpm
Max Copy Resolution600 x 600 dpi
Scan Resolution600 x 600 dpi
Warm-up Time25 seconds
Fax Resolution200 x 200 dpi
Paper Capacity1, 100 sheets
Max Paper SizeA3
Duplex PrintingYes
FunctionsPrint, Copy, Scan
Zoom Range25% to 400%
Supported Paper SizesA4, A5, B5
Network ConnectivityOptional (Ethernet)
USB ConnectivityUSB 2.0
Weight28.5 kg

Related product manuals