46
CONVENIENT COPY FUNCTIONS
JOB BUILD MODE
Use this function when you need to copy more originals than can be placed in the RSPF at once. (The maximum
number of originals that can be placed in the RSPF at once is 100.)
Example: Copying 130 sheets (A4 (8-1/2" x 11") size originals)
1
Touch the [JOB BUILD] key in the
special modes menu screen.
The [JOB BUILD] key is
highlighted.
The job build copy icon
( ) will also appear in
the screen to indicate
that the function is
enabled.
2
Touch the [OK] key in the special
modes screen.
You will return to the
main screen of copy
mode.
3
Place the original(s) in the RSPF.
(p.24)
4
Make sure that a suitable paper size is
selected, select the number of copies
and any other desired copy settings,
and then press the [START] key ( ) .
Scanning begins. When
scanning of the first set
of originals (A in the
above example) is
finished, insert the
second set and press the
[START] key ( ).
Repeat this step until all the remaining originals (B in
the above example) have been scanned.
Remove each scanned set of originals before inserting
the next set.
5
Touch the [READ-END] key.
Copying begins.
• If the memory becomes full while scanning the originals, "MEMORY IS FULL. PRESS [START] TO BEGIN
COPYING OR [CA] TO CANCEL." will appear. To copy only the originals that have been scanned, press the
[START] key ( ) . To cancel the job, press the [CLEAR ALL] key ( ).
•
Depending on the content of the originals, the memory may become full before 100 originals have been scanned. In
this case, press the [START] key ( ) to copy the originals that have been scanned, and then place the originals that
weren’t scanned in the RSPF once again and repeat the copy procedure.
• To increase the number of originals that can be scanned, install more memory or increase the memory
allocation in the administrator settings. (See "6. SYSTEM SETTINGS (ADMINISTRATOR)".)
Note
Originals
* Divide the originals into sets so that each set is no more than
100 pages. Scan the sets in order beginning from the first
page of set A.
100 sheets 30 sheets
page 1 page 101
MUL
ERASE
JOB
BUILD
D
JOB
BUILD
1/2
OK
JOB
BUILD
DUAL PAGE
COPY
To cancel the job build mode function, touch
the [JOB BUILD] key in the special modes
screen so that it is no longer highlighted.
(See the screen of step 1.)
READ-END
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
Note
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
