38
CONVENIENT COPY FUNCTIONS
STAPLE SORT
(when the finisher (MX-FN13) is installed)
This function collates the copies, staples each set, and delivers the sets to the offset tray. The staple sort function
can only be used when a finisher is installed.
ORIENTATION OF THE ORIGINAL AND STAPLING
POSITIONS
Using the RSPF
Insert the originals face up.
Using the document glass
Place each original face down.
When copying B4 or A3 (8-1/2" x 14" or 11" x 17") vertically oriented originals, the copies will be stapled at the
position shown below.
Stapling position
Top left corner
Portrait orientation
Landscape orientation
Available paper sizes:
A4, B5 (8-1/2" x 11")
Stapling capacity:
For each size, up to 50 sheets
can be stapled.
Available paper sizes:
A3, B4, A4R, B5R
(11" x 17", 8-1/2" x 14",
8-1/2" x 13", 8-1/2" x 11" R)
Stapling capacity:
A3, B4 (11" x 17", 8-1/2" x 14",
8-1/2" x 13")
For each size, up to 30 sheets
can be stapled.
A4R, B5R (8-1/2" x 11"R)
For each size, up to 50 sheets
can be stapled.
Stapling position
• When using letterhead paper in the staple sort, load the paper with the letterhead to
the front or to the right as shown in the diagram.
• When the staple sort is used, the automatic original image rotation function does not operate.
• Different sized originals cannot be copied on the corresponding sizes of paper.
• The staple sort function cannot be used if disabled in the administrator settings. (See "6. SYSTEM SETTINGS
(ADMINISTRATOR).)
• The offset function (p.36) cannot be used.
RSPF
Stapling position
Document glass
Stapling position
Note
SHARP
SHARP
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
