86
TRANSMITTING METADATA
Follow the steps below to select a metadata set, enter each item, and perform metadata transmission.
1
Touch the [DATA ENTRY] key.
2
Touch the key of the metadata that
you wish to use.
3
Touch the [OK] key.
4
The keys of the items stored in the
metadata set will appear. Touch the
key of the item that you wish to enter.
5
Touch the key of the value that you
wish to enter.
• If the entry values of the metadata item were stored
in selection format, the selections will appear as
keys. If a value is editable, the [DIRECT ENTRY] key
can be touched to manually enter a value.
• If a metadata item requires the entry of text, a text
entry screen will appear. Enter the required
information.
6
Touch the [OK] key.
7
Enter all items.
If no metadata sets have been stored, the
[DATA ENTRY] key cannot be selected.
Store a metadata set in the Web pages and
then perform the transmission procedure.
If you selected the wrong metadata set,
touch the [METADATA SET] key and return
to the screen of step 3. Metadata items
entered to that point will not longer be
effective.
ADDRES
ADDRES
DATA ENTRY
SEND S
Note
OK
METADATA 2
METADATA 4
METADATA 6
METADATA 8
1/2
CANCEL
OK
ATA 2
ATA 4
ATA 6
ATA 8
1/2
CANCEL
READY TO SEND
.
(DATA ENTRY MODE)
DATA ENTRY
User ID
Pass Code
Bill Code
METADATA SE
Note
• To change the number of items that
appear at once, touch the display item
number select key. Each time the key is
touched, the number of items displayed
switches between 3 and 6.
OK
Value2
Value4
Value6
1/9
CANCEL
DIRECT ENTRY
3 6
Note
OK
Value2
Value4
Value6
1/9
CANCEL
DIRECT ENTRY
3 6
READY TO SEND
.
(METADATA SEND MODE)
DATA ENTRY
User ID
Pass Code
Bill Code
Value2
xxxxxx
xxxxxx
METADATA SET
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
