15
BEFORE USING THE MACHINE
1
INITIAL SETTINGS
The machine reverts to the initial settings when it is first turned on, when the [CLEAR ALL] key ( ) is pressed, or the
preset "auto clear time" elapses after the last copy is made in any mode. When the machine reverts to the initial
settings, all settings and functions selected to that point are cancelled. The auto clear time can be changed in the
administrator settings. (See "6. SYSTEM SETTINGS (ADMINISTRATOR)".)
The initial settings that appear in the display are shown below.
Functions and settings are explained based on the above screen as applicable.
Copy ratio: 100%, Exposure: Automatic, Copy quantity: 0, Automatic two-sided: One side to One side,
Auto paper selection: On,
Paper tray: Upper paper tray
POWER SAVE MODES
The machine has two power save modes to reduce overall power consumption and thereby reduce the cost of
operation. These modes help conserve natural resources and reduce environmental pollution. The two power save
modes are "Preheat mode" and "Auto power shut-off mode".
The time settings for each mode can be changed in the administrator settings. (See "6. SYSTEM SETTINGS
(ADMINISTRATOR)".)
Preheat mode
When the set time elapses, the temperature of the fusing unit is automatically lowered to reduce power consumption
while on standby. To return to normal operation, touch any key on the operation panel. To make a copy when the
machine is in this mode, simply select the desired copy selections and then press the [START] key ( ).
Auto power shut-off mode
When the set time elapses, the power to the fusing unit automatically turns off to reduce power consumption. (This is
based on the guidelines of the International Energy Star Program.) When the machine enters this mode, the touch
panel screen turns off and only the [START] key ( ) blinks. To return to normal operation, press the [START] key
( ). To copy after warm-up starts, make desired copy selections and press the [START] key ( ). When the
machine receives a fax or a print job, Auto power shut-off mode automatically deactivates and the machine returns
to normal operation.
The initial settings can be changed in the administrator settings. (See "6. SYSTEM SETTINGS
(ADMINISTRATOR)".)
For the initial settings (initial screen) of printer, fax, and scanner modes, see the operation manuals of those
modes.
A4
A4
A4
A3
Note
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
