Specifications
DUSTHUNTER T · Operating Instructions · 8012428 V 2.0 · © SICK MAIHAK GmbH Germany 111
Compliances
The technical design of this device complies with the following EU directives and EN stan-
dards:
● EU Directive NSP (Electrical equipment designed for use within certain voltage limits)
● EU Directive EMC (Electromagnetic compatibility)
Applied EN standards:
● EN 61010-1, Safety requirements for electrical equipment for measurement, control
and laboratory use
● EN 61326, Electrical equipment for measurement technology, control technology and
laboratory use - EMC requirements
● EN 14181, Quality Assurance of Automated Measuring Systems
Electrical protection
● Insulation: Class of protection 1 according to EN 61010-1.
● Insulation coordination: Measuring category II according to EN 61010-1.
● Contamination: The device operates safely in an environment up to degree of contami-
nation 2 according to EN 61010-1 (usual, not conductive contamination and temporary
conductivity by occasional moisture condensation).
● Electrical energy: The wiring system to the mains supply voltage of the system must be
installed and fused according to the relevant regulations.
Approvals
The DUSTHUNTER T100 and DUSTHUNTER T200 versions are approved according to EN
15267 and may be used for continuous emission monitoring in plants requiring approval
and plants according to the 27th FICA.
To Next Page
Loading...
Need help?
General
