Important Information
GMS800 · Operating Instructions · 8013025 V1.2 · © SICK MAIHAK GmbH 11
Subject to change without notice
1.5 Responsibility of user
intended users
b
The GMS800 may only be installed, started and maintained by skilled technicians who,
based on their technical training and knowledge as well as knowledge of the relevant
regulations, can assess the tasks given and recognize the hazards involved.
Correct use
b
Only use the GMS800 as described in the Operating Instructions. The manufacturer is
not responsible for any other use.
b
Carry out the specified maintenance work.
b
Do not remove, add, or change any components in the device unless such changes are
officially allowed and specified by the manufacturer. Otherwise
– the device may become dangerous
– the manufacturer’s guarantee becomes invalid
– the Type Examination Certificate becomes invalid (only for ATEX versions).
Special local requirements
b
In addition to these Operating Instructions, observe all local laws, technical rules, and
company-internal instructions valid at the site where the device is installed.
Responsibility for dangerous substances
Safety precautions examples:
b
Attach warning signs to the device.
b
Position warning signs in the operating area.
b
Inform persons who can be in the area on safety-relevant aspects.
Keeping documents
b
Keep these Operating Instructions and all associated documents available for
reference.
b
Pass the documents on to a new owner.
WARNING: Mortal/health danger as a result of a gas path leakage
When the sample gas contains noxious substances: Leaks in the gas path can
be an acute danger for persons.
b
Set up appropriate safety precautions (e.g. monitoring of ambient air with a
gas detector, room ventilation, enclosure purging, monitoring of purge
gases, instruction of personnel, emergency plan).
b
Make sure the safety precautions work permanently and are complied with.