Operation
GMS800 · Operating Instructions · 8013025 V1.2 · © SICK MAIHAK GmbH 37
Subject to change without notice
5.4 Behavior in an emergency
Fire:
1 Stop gas feed to the GMS800.
2 Disconnect the GMS800 from the mains voltage (mains switch or emergency switch).
3 Switch off possible peripheral devices (e.g. heater).
4 Trigger an alarm/make an emergency call.
5 Follow the local Operating Instructions governing behavior when fire breaks out.
6 Inform the fire brigade about dangerous gases when necessary.
Unsafe operating state (
→
p. 36, §5.3.2):
1 Stop gas feed to device.
2 Disconnect the device from the mains voltage (mains switch or emergency switch).
3 Prevent unauthorized or unintentional start-up.
4 Protect the measuring system against condensation and penetration by liquids.
If a protection device is defective (when fitted):
1 Disconnect the GMS800 from the mains voltage (mains switch or emergency switch).
2 Stop gas feed to the GMS800.
3 Prevent unauthorized or unintentional start-up.
4 Protect the measuring system against condensation and penetration by liquids.
WARNING: Hazards through a gas leak
b
When gas escapes uncontrolled: Immediately check whether the gas can
be dangerous to health or combustible.
If this is the case: Immediately follow the local Operating Instructions that
govern behavior during uncontrolled escape of gas.
To Next Page
Loading...
