Operating Instructions FLOWSIC100
Gas Velocity Monitor
Product Description
8012513/03-2008 © SICK MAIHAK GmbH · Germany · All rights reserved 33
Operating keys
The following functions are additionally available in the display module:
– Commissioning by setting of installation parameters
– Initiating of a check cycle
– Switching to the Maintenance Mode.
2. I/O module
For plugging on module carriers, communication via I²C bus, optionally as:
– 2x analog output 0/4 ... 22 mA to output further measured variables (load 500 Ω)
– 2x analog input 0/4 ... 22 mA to read in values from external sensors
Notes: • One module carrier is necessary for each module (to insert on top hat rail). One module
carrier has to be connected to the processor board with a special cable, other module
carriers can be docked to it.
• Max. 8 I/O modules can be plugged, max. 4 modules of these may be of the same type.
3. Interface Module
Profibus DP-V0 to transfer
via RS485 according to
DIN 19245 Part 3 as well
as IEC 61158.
Module to pass measured values, system status and service information to higher level
control systems, optional for Profibus and Ethernet, To insert in slots (see Fig. 2.21).
Key Function
Meas
• Selection of the measured value to be displayed
• Switching between text display and graphical display
• Display of the constrast settings (after 2.5 s)
Arrows
• Selection of next/previous measuring value page
Status • Display of alarm or error messages
Menu
• Display of main menu
To Next Page
Loading...
