SICK DUSTHUNTER T

Product Description
DUSTHUNTER T · Operating Instructions · 8012428 V 2.0 · © SICK MAIHAK GmbH Germany 25
Options
The options described in the following serve to extend the functionality of the MCU
considerably:
1 Display module
Module to display measured values and status information of the connected sender
unit and configur the setup, selection via control keys.
–Displays
The graphic display shows two main measured values of a connected sender/
receiver unit selected at the factory or calculated values from the MCU (e.g. scaled
dust concentration) as bar charts. Alternatively, up to 8 single measured values of a
sender/receiver unit can be displayed (toggle with "Meas" button).
Figure 14 LC-Display with graphic (left) and text (right) display
● Fitting this module in control units already delivered must be done at
the factory.
● This module is standard on DUSTHUNTER T200 version.
Type Display
LED
Power (green) Power supply OK
Failure (red) Function fault
Maintenance
request (yellow)
Maintenance requirement
LC-Display
Graphic display
(main screen)
– Dust concentration
–Opacity
Text display
5 measured values (see graphic display) and 7
diagnosis values (
→ p. 83, Fig. 69)