Operating Instructions FLOWSIC100
Gas Velocity Monitor
Commissioning and Configuration
8012513/03-2008 © SICK MAIHAK GmbH · Germany · All rights reserved 113
Assigning a New IP-Address to the Ethernet Module
If an IP-address was specified by the customer when the device was ordered, this address
was set by the manufacturer.
If no IP-address was specified, the default address 192.168.0.10 is set.
Complete the following procedure to change the address:
‡ Go to the ‘‘Network Scan Assistant” and click the ‘‘Network Configuration” button.
‡ Go to the subpage ‘‘Internet Protocol / Internet Protocol (IP)”, activate the check box ‘‘En-
able IP Communication” and click the ‘‘Add” button.
‡ Enter the desired IP-address and affirm with the OK button.
Fig. 4.32: IP address specification (example)
To Next Page
Loading...
