Operating Instructions FLOWSIC100
Gas Velocity Monitor
Commissioning and Configuration
8012513/03-2008 © SICK MAIHAK GmbH · Germany · All rights reserved 119
4.4.5 Configuring the Display Settings with SOPAS ET
To change the factory settings, select the type MCU in the ‘‘Project Tree” window, enter the
password for user level 1 and go to the ‘‘Configuration / Display Settings” subpage.
Fig. 4.39: ‘‘Configuration / Display Settings” subpage
Field Description
Common Dis-
play Settings
Language Language used on LCD display
Display Unit System Unit system used on LCD display
Overview
Screen
Settings
Source Sensor
(1) to (8)
Sensor address for the first measuring bargraph of the
graphic display
Source Value Measured value index for the first measured value bar
Use A0 scaling If active, the measuring bargraph of the corresponding ana-
log output is scaled. If the check box is not checked, the
limit values must be defined separately.
Limit Low Values for the separate scaling of the measured value bar,
independent of the analog output
Limit High
To Next Page
Loading...
