5. DI and other status lamps: DI of all items and other statuses are designated as
visual signs. Full names of abbreviations are referred to the table below.
< Name >
[Table 2]
Each DI data is to display the status of measuring instrument. 1) Green is on
before any sign comes in 2) Red is on during operation 3) White is on if operation
has been made at least once in 5 minutes.
6. 02C: display oxygen calibration status, TMC: display temperature calibration status,
HDC: display hydrogen calibration status
The bars check calibration status. Green is on during calibration. Red is on when
calibration pauses at its configuration.
7. ZERO, SPAN, PUGE statuses of DO display timely progressive values and they
direct the values have not been calibrated. (Selected by F9 key, and toggled with
the values before setting up calibration and time)
8. Display the status of DATA LOGGER; it turns on red if it is not normal.
(It is on only when out of 4mA~20mA.)
9. Display percentage of data value when DATA LOGGER does normal operation.
(5min at basis)
To Next Page
Loading...
