Area of responsibility Target group Specific chapter in these operating instruc‐
tions
1)
Manufacturer Project engineers
(planner
s, developers,
designers)
"Design", page 27
"Technical data", page 81
"Accessories", page 95
Fitters "Installation and mounting", page 40
"Commissioning", pag
e 67
"Checklist for the manufacturer", page 98
Electricians "Electrical installation", page 42
Operators Operator "Troubleshooting", page 69
Maintenance person‐
nel
"Troubleshooting", page 69
"Or
dering information", page 93
Table 2: Assignment of target groups
1)
Chapters listed here are aimed at all target groups. All target groups must follow the safety notes and
w
arnings in the entire operating instructions!
In other applications the operating organization is at the same time the manufacturer
of t
he machine — with the corresponding assignment of the target groups.
1.4 Additional information
www.sick.com
The f
ollowing information is available on the Internet:
•
versions in other languages
•
data sheets and application examples
•
CAD data of drawings and dimensional drawings
•
certificates (e.g. EU declaration of conformity)
•
Guide for Safe Machinery (Six steps to a safe machine)
1.5 Symbols and document conventions
The following symbols are used in these operating instructions:
Safety notes and other notes
DANGER
Indicat
es a situation presenting imminent danger, which will lead to death or serious
injuries if not prevented.
WARNING
Indicat
es a situation presenting possible danger, which may lead to death or serious
injuries if not prevented.
CAUTION
Indicat
es a situation presenting possible danger, which may lead to moderate or minor
injuries if not prevented.
NOTICE
Indicat
es a situation presenting possible danger, which may lead to property damage if
not prevented.
ABOUT THIS DOCUMENT 1
8015836/YT10/2016-05-24 | SICK O P E R A T I N G I N S T R U C T I O N S | Flexi Loop
7
Subject to change without notice
To Next Page
Loading...
Need help?
General
