SICK GM35

78
8009441/YN36/V3-0/2015-08| SICKOPERATING INSTRUCTIONS|GM35
Subject to change without notice
START-UP
7.4.3 Electrical connections
SR-unit with purge air fixture
▸ Connect cables accordingly:
– Connect and secure the power supply cable to the underside of the SR-unit.
– Connect and secure CAN bus cable to EvU.
– Connect and secure the cable to reflector.
▸ Switch on the power supply for the SR-unit and the EvU.
Fig. 59: Cable connections on the purge air fixtures
Fig. 60: Cable connections on the SR-unit (underside)
CAN cable for SR-unit,
underside
CAN cable:
Connection for purge
air fixtures
Power supply cable CAN cable to purge air fixture
CAN cable to EvU