Siemens Clinitek Advantus User Manual

106 Clinitek Advantus Operator’s Guide
System Configuration
Network Settings
Specify network settings to send results to a local computer network.
1. Select Network settings.
2. Use the
IP configuration cycle key to set the configuration.
3. If you selected Static, enter a static IP address:
a. Select IP address.
b. Enter the IP address.
The header displays the numbers entered and adds the stop characters
in the correct positions.
c. Select
Enter.
4. If you selected DHCP, specify a DHCP name:
a. Select
DHCP name.
b. Enter a DHCP name of up to 16 letters.
c. Select
Enter.
5. To move to the next Network settings menu, select
Next Screen.
6. If you select IP configuration as
Static, use the Subnet mask cycle key to
set the subnet mask number.
7. Use the Gateway cycle key to activate a Gateway address.
To... Select...
use dynamically assigned IP addresses,
DHCP
use a static IP address,
Static
Key Options
Subnet mask 255.255.255.000
255.255.000.000
255.000.000.000
To... Select...
not use a gateway address,
No
make the gateway address active,
Yes

Siemens Clinitek Advantus Specifications

General

Test Types	Urinalysis
Interface	RS-232, USB
Calibration	Automatic calibration
Measurement Principle	Reflectance photometry
Sample Type	Urine
Power Supply	100-240 VAC, 50/60 Hz
Type	Urine analyzer
Display	Touchscreen
Reagent Type	Test strips
Measurement Parameters	Glucose, Bilirubin, Ketone, Specific Gravity, Blood, pH, Protein, Urobilinogen, Nitrite, Leukocytes