6.11.5.2 ESPA interface [NL]
The ESPA interface is used for transmitting event messages from the fire detection
installation to a pager system. The ESPA interface together with the installation
instruction can be obtained from suppliers.
The transmittable event types are as follows:
● Alarm
● Fault
● Technical message
● Activation
● Isolation
Connection and configuration:
See chapter 'RS232/RS485 module (Optional) [➙ 53]'.
6.11.5.3 Danger management system (DMS)
A DMS can be connected to the panel via UFP protocol using the physical RS485
module. Depending on DMS configuration and DMS manufacturers, the panel can
send alarm and trouble events to the DMS, and the DMS can acknowledge, reset
or silence/resound alarm events reported on the panel.
Connection and configuration:
See chapter 'RS232/RS485 module (Optional) [➙ 53]'.
To Next Page
Loading...
