9 Operation at Use of a PC
9.3 Configuration of the Device
173SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
9.3.3.1.4 LEDs
Default Settings and Setting Options of the LEDs
Parameterization of the LEDs
To change the outputs of the LEDs H1, H2, and ERROR, proceed as follows:
✧ In the navigation window, select the Operational parameters menu, then the Process connections
submenu and click LEDs.
Figure 9-31 Configure Tab, LEDs Input/Output Window
Table 9-5LED Settings
LED Default Setting Setting Options
RUN Device ready Not settable
H1 -none- Acc. to list box
(see chapter 16)
H2
ERROR -none- Errors are signaled as parameterized (only
error indications can be parameterized).
Acc. to list box
(see chapter 16)
Indication inverted no no
yes
MAN_SICAM_Q100_US.book Page 173 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
