Siemens SIMATIC IPC547D - Commissioning the device; Commissioning Requirements and Startup

SIMATIC IPC547D
Operating Instructions, 06/2011, A5E03473780-01
37
Commissioning the device
4
4.1 Requirements for commissioning
The following requirements have to be met before you can start commissioning:
● I/O devices, keyboard, mouse and monitor are connected.
● The power supply is connected.
The device can be supplied without an operating system. The following sections describe
commissioning with an operating system.
4.2 Switch on the device
4.2.1 Initial commissioning
Following the initial switch on, the operating system is set up automatically on the device.
CAUTION
Faulty installation
If you change the default values in the BIOS setup or if you turn off the device during
installation, you disrupt the installation and the operating system is not installed correctly.
The operating safety of the device and the plant is at risk.
Do not switch off the device during the entire installation process. Do not change the default
values in the BIOS setup.
Procedure
1. Press the on/off button.
The green POWER LED lights up. The module carries out a self-test. During the self-test,
the following message appears:
Press <F2> to go to Setup Utility
Press <F12> to go to Boot Manager
2. Wait for the message to disappear.
3. Follow the instructions on the screen.