EasyManua.ls Logo

Siemens SIMATIC IPC547D - Maintenance; Replacing Filters

Siemens SIMATIC IPC547D
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Device maintenance and repair
7.1 Removing and installing hardware components
SIMATIC IPC547D
68 Operating Instructions, 06/2011, A5E03473780-01
We are not liable for functional limitations caused by the use of third-party devices or
components.
Tools
You can make all repairs on the device with the following tools:
T20 screwdriver for
Device backplane
Device fan
PE terminal
T10 screwdriver for all of the remaining screws
Side cutter
7.1.2 Maintenance
To maintain high system availability, we recommend the preventative replacement of those
PC components that are subject to wear in accordance with the intervals for replacement
indicated in the table below.
Component Replacement interval:
Drive 3 years
CMOS backup battery 5 years
Fan 3 years
Filter mat Depending on the degree of soiling
To maintain high system availability, we recommend the preventative replacement of those
PC components that are subject to wear in accordance with the intervals for replacement
indicated in the table below.
7.1.3 Replacing filters
Requirement
The device is disconnected from the power network
The front panel cover is open
A filter mat
The order number is A5E02399219.

Table of Contents

Related product manuals