Device maintenance and repair
7.2 Installing the software
SIMATIC IPC547D
88 Operating Instructions, 06/2011, A5E03473780-01
7.2.8.2 Installing or updating user programs and drivers
A corresponding drive must be installed or connected for the installation of software under
Windows.
The USB floppy disk and CD-ROM drivers are included in Windows and do not have to be
installed from other sources.
For information about installation of SIMATIC software packages, refer to the corresponding
manufacturer documentation.
Contact the relevant manufacturer to obtain updates of drivers and user programs that you
purchased from third-party vendors.
NOTICE
Before you install new drivers or operating system updates for Windows versions, you need
to set the default language to US English in the regional settings for menus and dialogs.
7.2.9 Creating an image
We recommend the software tool SIMATIC IPC Image&Partition Creator for data backup
under Windows. This tool provides comfortable and efficient functions for backup and
restoring the full content of Compact Flash cards, of HDDs and of individual partitions
(images.)
Note
Hardware support
Older versions of the SIMATIC IPC Image&Partition Creator do not support the hardware of
the SIMATIC IPC. Support is only available as of version 3.x.
You can order this software from Industry Mall, the ordering system for automation and drive
technology (http://mall.automation.siemens.com
). For detailed information on the SIMATIC
IPC Image&Partition Creator, refer to the corresponding product documentation.
To Next Page
Loading...
