Device maintenance and repair
7.2 Installing the software
SIMATIC IPC547D
84 Operating Instructions, 06/2011, A5E03473780-01
1. Make sure that the partition on which you want to install the operating system is large
enough and is set up with a NTFS file system.
The recommended minimum size of this partition varies, depending on the operating
system, how much RAM you have available and how much additional software you want
to use. Information on how the data medium is partitioned in its delivery state is available
in the following tables.
2. Select the partition on which you want to install the operating system.
3. Click "Next".
Installation is started.
The Windows operating system is installed on the data medium.
Partitions in delivery state for Windows 7 32-bit and Windows Server 2008 32-bit
Partition Name Size File system
First SYSTEM 40 GB NTFS not compressed
Second DATA Remainder NTFS not compressed
Partitions in delivery state for Windows 7 64-bit and Windows Server 2008 R2 64-bit
Partition Name Size File system
First SYSTEM RESERVED 100 MB Automatically set up by installation
program
Second SYSTEM 40 GB NTFS not compressed
Third DATA Remainder NTFS not compressed
Information for systems with RAID or AHCI controller
Data carrier controllers unknown to the operating system must be made known to the
operating system prior to installation in the "Install Windows" installation program. Proceed
as follows:
Requirement
You have copied the relevant controller driver to a USB stick.
1. Connect the USB stick with the controller driver to the device.
2. Start the "Install Windows" installation program as described above.
3. Select "Load Drivers" in the Windows installation window.
4. Select the respective driver on the USB stick.
To Next Page
Loading...
