Siemens SIMATIC IPC647D - Connecting an AC Power Supply

Installing and connecting the device
3.3 Connecting the device
SIMATIC IPC647D
38 Operating Instructions, 01/2014, A5E32996306-AA
3.3.4.2
Connecting an AC power supply
Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching on the
device (Page 46)".
● 1 power cable
● 1 power plug latch from the accessory kit
● 1 T10 screwdriver
Procedure
Mounting
1.
Set the on/off switch
① to position '0'.
This prevents an automatic starting of the
device when plugging in the power cable.
2.
Remove the screws ③
.
3.
Plug the power cable plug ②
into the power
outlet.
4.
Plug the power cable plug into the power
outlet.
5.
Slide the power plug latch
④ over the plug.
6.
Secure the power plugs, if necessary, to prevent the power cables from becoming loose
accidentally: Secure the power plug latch with the screw ③.
7.
Set the on/off switch
① to position 'I'.
The yellow power LED on the front panel of the device lights up.
Removal
For installation, follow the steps for removal in reverse order.
WARNING
Risk of fire
If the power plug is secured with a clamp, the power outlet must be freely accessible to
allow the device to be easily removed from the mains.