Device maintenance and repair
7.2 Maintenance
SIMATIC IPC647D
84 Operating Instructions, 01/2014, A5E32996306-AA
You can make repairs on the device with the following tools:
● T20 screwdriver for protective conductor connection and enclosure
● T6 screwdriver for removing and installing the DVD drive
● T10 screwdriver for all of the remaining screws
Spare parts and repairs (http://support.automation.siemens.com/WW/view/en/16611927)
To maintain high system availability, we recommend the preventative replacement of those
PC components that are subject to wear in accordance with the intervals for replacement
indicated in the table below.
Depending on the degree of soiling
Changing the filter pad
Requirement
● The device is disconnected from the power supply, see chapter "Switching off the device
(Page 51)".
● The front panel is open, see chapter "Removing the front panel (Page 62)".
● A filter mat
You may only use filter mats of the same type. Information about original spare parts for
SIMATIC IPCs is available on the Internet at:
SIMATIC IPC after-sales information system (http://www.siemens.com/asis
).
Order no.: A5E02396171; 10 pieces per package
To Next Page
Loading...
