Expanding and assigning parameters to the device
6.5 Expansion cards
SIMATIC IPC647D
70 Operating Instructions, 01/2014, A5E32996306-AA
Removing and installing expansion cards
Requirement
● The bus frame has been removed in accordance with chapter "Removing and installing
bus frame (Page 68)".
● 1 T10 screwdriver
● 1 side cutter
● 1 retainer from the accessory kit
You may only use latching retainers of the same type.
Latching retainers are available under the Order Number A5E02719654.
● 1 mounting bracket for low expansion cards included with the retainers in the accessory
kit.
Note
Mounting bracket for low expansion cards
To guarantee the stable installation of a low expansion card, you need an additional
mounting bracket for latching
retainers. The mounting bracket may have to be removed
when you replace the low expansion card with a high one.
To Next Page
Loading...
